When I did my MGA's SU's a couple of years ago they came with some brass
flat washers which were to be used to help approximate the heighth of
stock needle and seat. This would minimize the amount of bending to the
float arm needed to set proper height. Just add washers where Grose Jet
threads in to carb.
Trevor Boicey wrote:
> Finally got my Grose Jets today. Any special tips on
> setting the float heights? Is it still the same method
> as the needles?
>
> The reason I ask is that the Grose Jets seem to have one
> fewer spring element in them so the "resting height" of
> the float when upside down may not be the same.
>
> --
> Trevor Boicey
> Ottawa, Canada
> tboicey@brit.ca
> http://www.brit.ca/~tboicey/
--
Bill Glanville '52 MGTD '58 MGA
Scottsville NY '59 MGA '67 MGB
glanvill@frontiernet.net '72 Midget
|