Chris,
A new unit just received from Moss (P/N 361-890) reads:
14 ohms at full tank
90 ohms at appx half tank
258 ohms when you ought to be lookin' for gas
Measured from ground (base of unit) to the wire spade connector with a
Fluke 75.
Hope this helps!
Hal
______________________________ Reply Separator _________________________________
Subject: Fuel guage sender ohms, second try
Author: Christopher T Palmer <ctp@gbn.org> at ccout
Date: 1/6/98 11:02 PM
Hi all,
I'm not sure if the original message made it to the list or not, or else I
lost the thread, or you're all just ignoring me ;)
I need to know the proper ohm readings for the fuel tank sender in an MG
Midget when full and empty...trying to isolate a fuel guage problem and
figured I'd tap an ohmeter into the sender line while filling the tank and
watch the resistance change, but...what's the range I should look for?
TIA,
CTP
|