Charles and all.
Moss Motors sends out a detailed instructions sheet with the
wire wheels when you buy a new wheel. Here in the shop we
have an old wire wheel hub built to fit onto the balancer
thus overcoming the problem describe below. Its my
understanding that the wheels and tyres for your car
orginally had been done with a bubble balancer.
Charles if you want, I;ll scan the sheet and email it to you
if you still need to know.
Regards, Jon Nyhus
> Local tire place says the outside hub surfaces are not
> always
> perpendicular with the splines and cause the wheels to
> wobble on the
> spin balancer. This makes true balancing difficult if not
>
> impossible because the balancer wants to compensate for
> the wobble.
> The only acceptable method I have found is to bubble
> balance. This
> doesnt do as precise a job as I would like. Any thoughts?
|