To: | mgs@Autox.Team.Net |
---|---|
Subject: | Re: Main bearing problem |
From: | John Middlesworth <jape@email.unc.edu> |
Date: | Thu, 31 Jul 1997 10:48:18 -0400 (EDT) |
I should add to my previous post that the bearings themselves are marked "std" so it's not a question of them being in the wrong box. Also, I cleaned off the surface where the bearings sit pretty well, so I don't think a film of oil or some residual dirt is to blame. Perhaps a shop should mic the bearings for thickness. If, so is there a figure available on how thick the standard bearings should be? John Middlesworth |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: The Calling, Matt Liggett |
---|---|
Next by Date: | Re: Bleeding Brakes, dmeadow |
Previous by Thread: | Main bearing problem, John Middlesworth |
Next by Thread: | Re: Main bearing problem, Ulix Goettsch |
Indexes: | [Date] [Thread] [Top] [All Lists] |