I've seen the vent pipe routed to inside the air cleaner where crank case
fumes would get recycled and no contaminates can enter the crank through the
vent pipe. Another option is to put a small length of hose about 3" on the
pipe and attach a K&N mini filter to it. Looks like a small cylinder 1.5"
dia X 2". You could even connect a pvc valve in between
Chris Reichle
----------
From: mgs-owner
To: mgs
Subject: Desmogging a 'B'
Date: Thursday,May 29,1997 5:13PM
>
> If you do all the following to your engine, what system is left to control
> crankcase ventilation?
>
> John Middlesworth
>
> On Mon, 26 May 1997, pbailey wrote:
>
> > Has anyone desmogged a later B? Taking the pump gulp valve off ,plugging
> > the air holes ,running the vacuum advance directly to the distributer
> > ,as described in Porter's DIY restoration guide?I know this isn't QUITE
> > legal but what if any would be the benifits of doing this it looks like
> > an easy job according to the book...Pat
>
To control crankcase ventilation, Bob at Brit-Tek recommended the
following to me: take a length of appropriate-size hose, and run it
from the riser on the engine side cover straight down so that it
terminates in the airstream below the car. Then cut off the end of
the hose on a slant, so the opening in the end of the hose is
oval-shaped, and facing towards the rear of the car. At driving
speed, this will pull the gases out of the crankcase. I knew exactly
what Bob was talking about, because this is the same setup we have to
draw off gas fumes on our T-34 aircraft at work. Lousy ASCII art
follows:
| |
| | <----hose from engine side cover
| |
| |
| /
| / <----Slant-cut tip rear of car------>>
| / below car in
|/ airstream
Hope this helps,
Scott Gardner
gardner@lwcomm.com
www.lwcomm.com/~gardner
|