Re: torque setting

[Wayne Kube <wkube@iadfw.net>]

ken hedges wrote:
> 
> does anyone know the correct torque for the axle nut that goes on the end
> of the half shaft?
> 
> Car is a 75B

Correct torque is 150 ft-lbs.  Then you tighten a bit further to allow
insertion of the split pin.

Good Luck!
-- 
Keep on keepin' on!

Wayne Kube              wkube@iadfw.net
1979 MGB                http://web2.airmail.net/wkube
Plano, TX       
Texas MG Register       http://www.tmgr.org
NAMGBR UK Site          http://www.mgcars.org.uk/namgbr
NAMGBR US Site          http://www.british-cars.org.uk/kimber/namgbr