Geoff Love wrote:
>
> Steve Tritle wrote:
> >
> > Geoff Love wrote:
> > >
> > > Steve Tritle wrote:
> > > >
> > > > Having traversed another 500 miles it was time to grease the TD. I took
> > > > care of all the fittings from the suspension to prop shaft to water pump
> > > > etc. But I found I do not have the fitting on my pedal shaft assembly.
> > > > It looks to have been removed and soldered over.
> > > >
> > > > Will or should this prove troublesome? Should I have another one
> > > > installed or leave well enough alone.The car was 'restored'almost 2
> > > > years ago and I have put over 3000 fun-filled miles on her.
> > > >
> > > > I certainly don't want to dismember my beloved TD to add a grease
> > > > fitting.
> > > >
> > > > Your valued thoughts are appreciated.
> > > >
> > > > Steve
> > > > 52 TD
> > >
> > > Steve: The grease fitting was put there for a specific purpose, namely
> > > to lubricate the foot lever shaft. It will be important to replace the
> > > nipple and to lubricate regularly as without grease on the shaft, the
> > > bushing on one pedal, and the bushings on the chassis box will suffer
> > > rapid wear. Check to see if the 'solder' is in fact the remains of the
> > > old fitting. If so, remove it with an easy out and replace it. You
> > > don't have to dismember the car to do the job.
> > >
> > > Geoff Love, The English Connection.
> > Thanks, Geoff. I am going to look at it again. It looks as though it has
> > been soldered or even welded and filed smooth. Can I still attempt to
> > drill it out. I can't find any schematics even showing it. I assume I am
> > loking at the right place....inside the frame toward the udercarriage
> > not toward the outside of the car.
> >
> > I wil go look again.
> >
> > Thanks,
> >
> > Steve
> > 52 TD
> Steve:
> I am not quite sure from your description where exactly you are looking
> for this grease nipple. It is located on the end of the shaft which is
> on the outside of the car, on the left hand side of the vehicle, and
> just below the left hand front wing. If you follow the approximate line
> of the shaft you will easily locate it in that position. Refer to
> Moss's catalogue for parts if you are having difficulty or let me know
> via this all eletric gadget.
>
> Geoff.
Geoff,
As I recall I am referring to the wrong side of the frame box. I think
there is an 'opening' of the shaft at the area in which you refer. Is
there a standard fitting I should look for or get one from Moss or
Abingdon Spares?
Thanks for all your help. This is an example of why this list is so
invaluable. I have corresponded to so many people who actually take the
time to help someone else. These are the very princples we are trying to
teach our children.
MG's...the best LBC with the best people!
Thanks again,
Steve
52 TD
|