Hi everyone,
Thanks for the advice re: changing the oil on my new (used) motor. I've
decided to change the oil & filter now, then run it for a few hundred miles
(depending on condition of oil) then replace again.
My next question:
Moss sells a clutch centering tool, which I gather is just a plastic repro
of the end of the tranny input shaft. Is there some other way to do it?
How 'bout a broomstick end? When I did VW's, we would just eyeball the disk
& make sure it was centered. Will that work?
Thanks for all the net-wisdom out there.......
Jim
79B
|