Roland,
Thanks for the suggestions. The slave is mounted correctly
with the bled screw up. I can't drive the car to shake out
all the air. Indeed, I can't get it into gear, so I don't
want to try driving it. It's not easy to get the bleed screw
and the flex line mixed up. I'm pretty sure there is only
one way round. The flex line enters the back of the slave
and the bleeder is at the top.
Alan
______________________________ Reply Separator _________________________________
Subject: Re: Q/Clutch/Midget
Author: cobra-at-cdc (cobra@cdc.hp.com) at HP-USA,shargw2
Date: 3/4/96 11:50 AM
>
> Who has some suggestions?
>
> Bled the lines sooo many times. Pushed the slave piston in
> while opening the bleeder.
>
> Spongy pedal still! Can't get it in gear with out grinding.
>
> What am I doing wrong? What Have I over looked?
>
> Alan
Alan,
Running copious amounts of fluid through the system does NOT guarantee
that all of the air has been removed. This is especially true if the
system started out dry. Believe me, I've gone through this. A spongy
pedal is the classic indication for air in the system. To completely
expel all the air may require many cycles of bleeding/driving. The
driving part dislodges trapped air bubbles which should then raise to
the highest point, which should be where the bleeder valve is. One
suggestion I've heard, but never tried for dislodging trapped air is to
use one of those vibrating metal scribing tools.
Another possible reasons for not being able to bleed a clutch is that
the slave was installed upside down. On many cars this is very easy to
do. I did it on the snake when I redid the hydraulics. I've talked to
a number of people who have also done this. Embarrassing, but easy to
fix.
In the last issue of the ACOC newsletter there was a letter from a
member with a story very similar to yours. He had installed a new
clutch slave on his ME3000. The slave had been shipped from the factory
with the bleeder valve screwed into the inlet because that was the only
way it would fit into the shipping box. There was apparently no mention
of this in the instructions that came with the new slave. The member
discovered this after checking another member's car, then calling the
manufacturer to confirm his suspicion.
Roland
|