I am currently rebuilding the brake master cylinder on my '77 B. The kit that
I got from the vendor contains a metal (brass?) cup and plastic (nylon?)
washer. When I disassembled the master cylinder, these parts were not
evident. I think that the parts are tied into the fitting of the master
cylinder into the servo; but I am unsure of the order that they fit together,
nor do I know the currect orientation of the washer, whiched is lipped on its
internal circumferance. I would appreciate it if some one could let me know
the proper sequencing of the vacuum seal, metal cup and washer, and the
orientation of the washer so I could finish this chore .
Thanks,
Mike McDevitt
|