Hi Tom
If you can't find it locally, McMaster-Carr is always a good bet (for
practically any value of "it").
http://www.mcmaster.com
- Derek
On Saturday 30 August 2003 09:51 am, T. S. White wrote:
> I read a tech article in the MGB-V8 newsletter about the installation
> of a hydraulic throwout bearing. Pert of the article recommended
> making a grommet for the hole where the old clutch arm went. The
> article recommended using 1/2 inch thick sheet rubber.
>
> Does anyone know where to get some 1/2" thick sheet rubber. I don't
> even know where to begin.
>
> Thanks,
> Tom
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|