I read a tech article in the MGB-V8 newsletter about the installation of
a hydraulic throwout bearing. Pert of the article recommended making a
grommet for the hole where the old clutch arm went. The article
recommended using 1/2 inch thick sheet rubber.
Does anyone know where to get some 1/2" thick sheet rubber. I don't
even know where to begin.
Thanks,
Tom
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|