Hi Telewest,
On my chrome bumper crossmember the rack is approx 1 1/2" above and approx 1"
forward of the front
of the crossmmeber. If the sump is near "touching" the crossmember, where does
the steering rack go?
Regards
Tony
Telewest (PH) wrote:
> If the factory V8 is anything to go by not only the top of the cross-member
> but the back of it too. It is so close that if the engine mounting plates
> are used on the wrong sides (they are handed but fit either side) the sump
> rests on the cross-member and wears through.
>
> ----- Original Message -----
> From: "Tony Bates" <tony@batesfamily.net>
> To: <mgb-v8@autox.team.net>; <buick-rover-v8@autox.team.net>
> Sent: Monday, December 09, 2002 9:25 PM
> Subject: MG V8 conversion
>
>
>
>>I am now at the "will it fit" stage with my Rover 4.2 installation in a
>
> 1974 chrome bumper MG
>
>>roadster. My question is what is the distance between the top of the
>
> crossmember and the bottom of
>
>>the sump (oil pan).
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|