mg-t
[Top] [All Lists]

Re: [Mg-t] spark plug wires

To: <sumton@sbcglobal.net>, "Bob Howard" <mgbob@juno.com>
Subject: Re: [Mg-t] spark plug wires
From: "Clive Sherriff" <clive.sherriff@ntlworld.com>
Date: Mon, 28 Sep 2009 16:29:15 +0100
I know suitable lengths for the spark plug leads,
and I know the Plug gap but I can't find anywhere
the specified ideal width (or diameter - is it
round? or perhaps oval?) of the spark itself.

Surely someone on the list will know!!!

Clive
Oxford UK
==================================
----- Original Message ----- 
From: "Bob Howard" <mgbob@juno.com>
To: <sumton@sbcglobal.net>
Cc: <mg-t@autox.team.net>
Sent: Monday, September 28, 2009 3:12 PM
Subject: Re: [Mg-t] spark plug wires


> Hi Oliver,
>   I checked through the T-Register CD looking for measurements without
> success.
>   My suggestion is to remove one at a time, measure the original and cut
> the new one to same length allowing for any loss where insulation is cut
> away, unless the original is too short in which case you would want to
> make the new wire an inch or two longer.
>   Some mark the spark plug connector with Roman numerals, I II III IIII,
> with a triangular file. It's inconspicuous, yet handy to have them
> marked.
>   Those little copper washers over which you spread the wires become
> invisible when dropped on the floor. Have a clean surface under your
> working area and plenty of light.
>   Finger snug is tight enough for the connections into the cap and for
> the screws in spark plug connections. The bakelite will crack if the
> connections are over tightened.
> Bob
>
>
> On Sun, 27 Sep 2009 15:32:46 -0500 "oliver" <sumton@sbcglobal.net>
> writes:
>> hi, all.
>>
>> purchased new spark plug wires (plus cap, rotor, and petronix).
>>
>> looks pretty easy to replace the existing wires, but was wondering
>> if anyone
>> had the preferred lengths (measurements) and if there are any tricks
>> or traps
>> i should know about.  this is my first foray into the "build it
>> yourself"
>> spark plug wires; i've read the directions and am pretty sure I know
>> how to do
>> it.
>>
>> thanks!
> ____________________________________________________________
> House Rescue Bill Passed
> $133,000 mortgage under $679/mo. Compare rates and save!
> 
>http://thirdpartyoffers.juno.com/TGL2141/c?cp=p6rLymS8h7QLuG9VBxPPDQAAJ1AZtbtuTpx5SVCdlh4YnsjUAAQAAAAFAAAAACvPhz4AAAMqAAAAAAAAAAAAAAAAAAaTcQAAAAA=
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> Mg-t@autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive 
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t

Archives at http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>