Re: tappet cover studs

["lawrie" <lawrie@britcars.com>]

Are you sure you don't mean 6 x 1 mm, Dave?

Lawrie


>  -------Original Message-------
>  From: Dave & Liz DuBois <ddubois@sinclair.net>
>  Subject: Re: tappet cover studs
>  Sent: 09 Sep '06 13:54
>  
>  A couple of 8 X 1mm nuts run down on the stud and jammed together should
>  back them out.  If the nuts slip on the stud before the stud turns,
>  apply heat to the bottom of the stud.  If it isn to entirely necessary
>  to remove the studs, then leave them in and clean up the threads with a
>  8 X 1mm die.
>  
>  Good luck,
>  Dave

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t