Re: tappet cover studs

[Dave & Liz DuBois <ddubois@sinclair.net>]

A couple of 8 X 1mm nuts run down on the stud and jammed together should 
back them out.  If the nuts slip on the stud before the stud turns, 
apply heat to the bottom of the stud.  If it isn to entirely necessary 
to remove the studs, then leave them in and clean up the threads with a 
8 X 1mm die.

Good luck,
Dave

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t