The wiper motor on my 1951 TD blew a fuse. Replaced the fuse, not blow
again, but no motor movement. There is 12 v dc at the motor terminals. How
do I remove the outer case to inspect? I removed the screw recessed in the
manual lever control (as well as the screws on either side of the case), but
I cannot remove the handle. Looking at the picture in the Workshop Manual,
page N.14, it appears the manual lever is screwed on the shaft. It will not
unscrew, even though I hold firm the motor/wiper shaft. Is there some
locking mechanism that holds the handle from unscrewing once the center
screw is removed? Which way does the handle unscrew - CW or CCW?
Thanks
Stu Keen
1951 MGTD Mark II
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|