Bob, I just caught the tail end of the discussion on your engine. But the
last one I noticed that their was some comments on using two head gaskets.
I just had my engine milled for a total overhaul, and I found that I also
needed two gaskets because we couldn't zero out the rocker assembly because
it was milled. I was going to use two gaskets but my MG mechanic talked me
out of it. Instead, we used shims under the rocker assembly. I just needed
one set of shims. Now I am glad he talked me out ot it. My engine runs
great, and I don't worry about blowing a head gasket either.
Have you thought about putting shims under the rocker assembly insteadd of
two head gaskets?
Bob
Freehold, NJ
|