Re: PA windscreen measurement

[Jerry Felper <felperg@earthlink.net>]

DB35PA@aol.com wrote:

> Hello all,
>
> Because of copious amounts of rot, I had to chop out and replace both sides  
> of the scuttle in the area of the mounting holes for windscreen upright  
> supports.
>
> Failing to think ahead, I did not capture the exact locations of holes and  
> now don't know where to place windscreen. Yes Tom, I know it goes on the front  
> end of the car, ahead of the driver!
>
> Would one of you kind PA owners send me measurements from front edge  of 
> scuttle to bottom center of windscreen?
> I'm also concerned about the rake angle of screen. Again, anyone have a  
> protractor (or alternative) to determine proper rake  when screen is fully  
> upright?
>
> Thanks in advance,
>
> Don B.
>
> ///  unsubscribe/change address requests to majordomo@autox.team.net  or try
> ///  http://www.team.net/cgi-bin/majorcool
> ///  http://www.team.net/mailman/listinfo
> ///  Archives at http://www.team.net/archive/mg-mmm
> ///  Send list postings to mg-mmm@autox.team.net
>
>
>  
Don
I would use the top to position the windscreen. I think there was a 
great variation.
Jerry

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net