Re: PA/PB Front Fairing

["Peter Green" <p.green@mgk3.co.uk>]

Lew,

The chassis has a tapped 1/4" BSF hole. I think, but I am not certain, that 
a bolt was screwed upwards through the chassis and the apron was held down 
with a chromed domed nut and washer.

Regards,

Peter.



----- Original Message ----- 
From: "Lew Palmer" <lpalmer@roundaboutmanor.com>
To: "MMM List" <mg-mmm@autox.team.net>
Sent: Friday, January 13, 2006 10:07 PM
Subject: PA/PB Front Fairing


> Could someone please tell me what size fasteners are use to hold down the
> front fairing between the fenders? I see from photos that the dome nuts 
> and
> flat washers are on top of the fairing, but I cant tell whether they are 
> <
> or 2 BA. The reason I ask is that the two holes in the chassis on the off
> side of the car are slightly larger than <. One on the near side is only
> large enough to pass a 2 BA or 10-32 screw, yet the other hole on the near
> side chassis rail is tapped for a < BSF bolt.
>
>
>
> If the holes were not tapped, what holds the screw in when the fairing is
> removed?
>
>
>
> Cheers,
>
> Lew Palmer
>
> ///  unsubscribe/change address requests to majordomo@autox.team.net  or 
> try
> ///  http://www.team.net/cgi-bin/majorcool
> ///  http://www.team.net/mailman/listinfo
> ///  Archives at http://www.team.net/archive/mg-mmm
> ///  Send list postings to mg-mmm@autox.team.net
///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net