Could someone please tell me what size fasteners are use to hold down the
front fairing between the fenders? I see from photos that the dome nuts and
flat washers are on top of the fairing, but I cant tell whether they are <
or 2 BA. The reason I ask is that the two holes in the chassis on the off
side of the car are slightly larger than <. One on the near side is only
large enough to pass a 2 BA or 10-32 screw, yet the other hole on the near
side chassis rail is tapped for a < BSF bolt.
If the holes were not tapped, what holds the screw in when the fairing is
removed?
Cheers,
Lew Palmer
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|