Hi Pete,
My 2 seat PA also has the belly pan under the gearbox and the panel under
the driveshaft. Fastenings for the driveshaft panel are studs sticking up so
I assume this is standard PA.
Gearbox rebuild proceeding, I have all new bearings so can re-assemble.
I do need the rubber bushings for the rear mount cross shaft that passes
through the clutch bell housing. Any suggestions where I can get these
rubbers? The old ones are mush.
Thanks and Regards, Bob
PA-0531
Bob Grunau
150 Pinewood Trail,
Mississauga, Ontario,
Canada, L5G-2L1
905-274-4136
Don, Peter, et al,
The floor board securing studs were reversed to captive nuts at least by
the TC...don't know about the TA/B. So you are on the track the factory
eventually took.
Incidentally, the PA I just acquired has not only the full belly pan under
the transmission area, but there is also a small panel under the drive
shaft that also installs on the studs under the tunnel cover completely
enclosing the drive shaft. Being new to the P-types, is this usual??
Pete Thelander
pthelander@earthlink.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|