Re: L type clutch question

["J.E.A. Rich" <mmmbob@adelphia.net>]

Bill,

The sun came out and the temperature went up to 10: below freezing!

I have to have my memory jogged a bit and I have done that. I made the 
6 pins that I have from #8 grade steel bolts. I never had any originals 
so don't know the correct length but the ones I made are 2.90" long and 
worked fine. They have a couple of flats on the top to give a surface 
for a spanner to screw them in and 1/4" BSF threads on the bottom. 
There  are 7/16" of threads and the flats are 3/8" long and deep enough 
to leave 3/16"  of metal for the spanner. I hope this helps.

Cheers, "Bob".

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net