?
Bob,
On my PA1212, the measurements from the centerline of the bulkhead are 4.25"
and 6.75", with the top of the pump at center 2" below the channel molding that
carries the fume seal.
My bulkhead is original to the car. Perhaps at the works they eyeballed things,
rather than following a template?
Cheers,
Phil Anderson
________________________________
From: owner-mg-mmm@autox.team.net on behalf of Robert Grunau
Sent: Sat 8/14/2004 2:31 PM
To: mg-mmm@autox.team.net
Subject: PA SU Fuel Pump Location
Can someone give me the correct SU fuel pump location on a 2 seat PA. The
restorer of the car in 1975 had originally fitted an SU pump but I believe
in the wrong location. The pump body is outside the rear carb and just
inside the rad stay rod. The rad stay rod fouls the pump intake unless a
pigtail of plastic hose is used. The firewall during the restoration was
replaced so no old holes to use as clues.
Looking at the PA Instruction Manual, page 10, shows the pump well inboard
of the carbs. However before I go drilling more holes in the firewall, I'd
appreciate a more precise vertical and horizontal location.
Thanks for any help.
Best regards, Bob , PA-0531
Bob Grunau
150 Pinewood Trail,
Mississauga, Ontario,
Canada, L5G-2L1
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.736 / Virus Database: 490 - Release Date: 8/9/2004
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|