Bob,
The petrol pump on my PB is in exactly the same position as shown in the PA
Instruction Manual.
On my car the centre of the petrol pump mounting holes are 3.75" and 6.25",
in board, from the centre line of the vertical bulkhead mounting bolts. If
you would like any more measurements I will supply them.
Regards,
Peter Green.
----- Original Message -----
From: "Robert Grunau" <cgrunau@pathcom.com>
To: <mg-mmm@autox.team.net>
Sent: Saturday, August 14, 2004 8:31 PM
Subject: PA SU Fuel Pump Location
> Can someone give me the correct SU fuel pump location on a 2 seat PA. The
> restorer of the car in 1975 had originally fitted an SU pump but I believe
> in the wrong location. The pump body is outside the rear carb and just
> inside the rad stay rod. The rad stay rod fouls the pump intake unless a
> pigtail of plastic hose is used. The firewall during the restoration was
> replaced so no old holes to use as clues.
> Looking at the PA Instruction Manual, page 10, shows the pump well inboard
> of the carbs. However before I go drilling more holes in the firewall, I'd
> appreciate a more precise vertical and horizontal location.
> Thanks for any help.
> Best regards, Bob , PA-0531
> Bob Grunau
> 150 Pinewood Trail,
> Mississauga, Ontario,
> Canada, L5G-2L1
>
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.736 / Virus Database: 490 - Release Date: 8/9/2004
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or
try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|