Tom,
Having had my clock cleaned by a bad vibration damper, I'd check TDC
and make sure the mark on the damper agrees with the #1 piston.
Bryan
tom sarda wrote:
> Hey, any one know of considerstions,if any, when
> putting 305 heads on a 350 block as far as water temp
> control? I have no restrictor in the water neck. In
> about three minutes the temp goes to 220. I have a 500
> cfm carb on a quadra jet intake. There is an adapter
> plate between the carb and the intake. Could the
> intake need water flow from the rear (over cylinders 7
> and 8) to the waterneck to allow flow to the radiator?
> Any one had this problem or is it not a problem. The
> motor is running a bit rough so I will now check for
> vacuum leaks. Suggestions on timing would be helpful
> if you have any. I have set initial timing to 10
> before tdc. I think I want 36 total. The plugs are AC
> 43's.
>
> thanks, tom
|