Whatever it is your fabricating for, wouldn't it be easier to modify an
existing cap to work for your application?
Dick J
In East Texas
atrav <atrav@copper.net> wrote:
What would be a good material to fabricate a distributor cap from?
I was thinking a block of nylon, then using screw in brass terminals. Is there
a rule for how far
apart the terminals should be spaced to prevent arcing from one to another? I
was just going to
measure a bunch of factory stock ones...
TIA,
-Aron-
---------------------------------
Sell on Yahoo! Auctions - No fees. Bid on great items.
|