Doc,
"put a non directional finish on them"
I've used a random orbital sander on rotors with 400 paper, I this what
you mean?
Thanks,
Bryan
docb8532@aol.com wrote:
> In a message dated 6/1/04 9:01:12 PM Eastern Daylight Time,
> b.a.savage@earthlink.net writes:
>
> All four surfaces on the rotors look similar. The spots are very
> shiny.
>
>
> We see rotors like this every day. The shiny spots are hard spots in
> the metal probably caused by heat and hard stops. We check two things
> on rotors like this....Total indicated run out and rotor
> thickness...and compare to mfg specs.........If there's enough
> thickness we turn the rotors and put a non directional finish on
> them......wash with HOT SOAPY water and reinstall with new pads.
> Doc
|