Todd, Go to www.tinmantech.com then go down to All New Pages then
look for How to set your torch I think there is some feed back
abiout the Henrob torch on his site also. Doug Odom in big ditch
todd wrote:
>Thank you Rich, this is the kind of feedback I was looking for(i'm all for
>the kids and what hens weigh.. blah blah, but again it has nothing to do with
>the subject line and I end up having to go thru a too much other stuff to
>read replies to subjects i'm interested in). I believe changing the subject
>line if needed is part of editing a reply is it not?, if not it sure would
>help.
>Rich, I've noticed my acet fluctuating quite a bit(in comparison to it's
>reccomended 4lb setting) but oxyg is staying put well. Did you change your
>regulators, and did it help if so? Cutting is much better controlled then
>then standard torch. Sure hope to get half as proficient welding with this
>thing as the guy in the video(this should come in handy at the track as well
>as reducing setup time of a regular welder for small stuff here).
>Todd-
>
>
>
>>I have one and like it. Found that my El'Cheapo regulators couldn't hold
>>the pressure steady at low PSI when using the small tips for gas welding.
>>RichK
|