Dick;
Nothing to it (at least on a Chevy)--just be careful not to warp the rotor.
Regards, Neil Tucson, AZ
-----Original Message-----
From: Dick J [mailto:lsr_man@yahoo.com]
Sent: Friday, July 11, 2003 1:37 PM
To: land-speed@autox.team.net
Subject: Mustang rear axle
I need to replace a broken wheel stud on my daughter's 96 Mustang with rear
disc brakes. Has anybody done this? Is it so different than doing it on a
Chevy (Knock the old one out with a hammer, pull the new one in place with
an impact wrench, lug nut and spacer)? She was going to have the Ford
garage do it, and they wanted $80+ ???? I bought the parts for two bucks
this morning. I figure that even if I have to remove the caliper and pull
the axle I can do it for a lot less than $80!
Dick J in East Texas
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|