Re: welders

To:	James.Waldron@CWUSA.COM, land-speed@autox.team.net
Subject:	Re: welders
From:	Nt788@aol.com
Date:	Fri, 9 May 2003 14:09:52 EDT

In a message dated 5/9/2003 10:55:56 AM Pacific Daylight Time, 
James.Waldron@CWUSA.COM writes:

<< If you are going to use a stick, there are special rods made for overhead 
use. >>
Good info Skip! Jack

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.

<Prev in Thread]	Current Thread	[Next in Thread>
Re: welders, (continued) Re: welders, John Goodman Re: welders, LGMCAFEE Re: welders, Jim Dincau Re: welders, John Goodman Re: welders, Skip Higginbotham Re: welders, Chris Harris Re: welders, John Goodman Re: welders, ardunbill RE: welders, Waldron, James Re: welders, Nt788 Re: welders, Nt788 <= RE: welders, Albaugh, Neil Re: welders, Jim Dincau RE: welders, Albaugh, Neil Re: welders, Jim Dincau RE: welders, Albaugh, Neil

Previous by Date:	RE: Torque Converter Slippage, Albaugh, Neil
Next by Date:	RE: LSR claimed by the Air Force, Albaugh, Neil
Previous by Thread:	Re: welders, Nt788
Next by Thread:	RE: welders, Albaugh, Neil
Indexes:	[Date] [Thread] [Top] [All Lists]