> What is the easiest type to use when welding overhead?
Gee folks, I asked for the easiest not best, or most cost effective method.
So far I get, two votes for TIG, one and one half votes for MIG, one and one
half votes for stick and one half vote for braze.
Jim in Palmdale, still wondering
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|