Enough, already! I know the subject title is wide-open for jokes, butt
lets get beyond that. . .
Its obvious the start of a drag race is brutal to the drive train. However,
I'm not sure LSR is a whole different matter. Even though the LSR launch
appears to be moderate via a push-start or self-start once you hit that
impermeable wall of drag, maximum horsepower (twist) is being applied to the
drive train. So, in LSR what read-end treatment is needed? Anything from
slapper bars, ladder bars, to a complex 4-link? I'm not sure of the
necessity of a 4-link but since LSR is new to me any and all ideas are
encouraged. If a production car already has coil springs and a drag link,
is just replacing the rubber bushings good enough? At what H.P. level would
you start to eliminate (or beef up) the stock set-up?
-Elon, (450 hp Production Car)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|