For the many requests.
I will be cutting mostly round and square tube under
1 1/2 inch in diameter, some U channel (2" x 1/2"), and
plate and flat iron up to 1/4" thick. Perhaps an
occasional piece of 3/8" or 1/2" plate.
Tube cuts will be at various angles, channel and flat
mostly square cuts. Pieces cut from the plate will
be in various shapes.
An O/A torch is my only existing choice for the plate.
Looks like recommendations for the others are a chop saw
or metal band saw.
Thanks,
Jim W.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|