Can anyone tell me roughly what clearances should be between a camshaft
and the bearings it spins on. On more than one Big Block Mopar engine I 've
had problems getting the cam to fit into the block after installing new
bearings but I don't know how much clearance to give the cam anyways when we
wet sand the cam to fit the bearings. Scott
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|