I looked into it but does not have the physical properties that I needed.. been
using 2024 T4
Dave
"Albaugh, Neil" wrote:
>
> Dave;
>
> You might try aluminum "tooling plate"-- it is made specifically for
> maintaining dimensional stability after machining. It is a special grade of
> stress-relieved cast aluminum plate.
>
> Regards, Neil Tucson, AZ
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|