Hi all,
The "tooling plate" we used at the old lazy L was dimensionally stable
but the alloy was an unknown. We suspected it was cast from remelted chips
as we once found a carbide tool bit imbedded in a piece. It had a very
course grain structure and wasn't very strong.
Jim in Palmdale
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|