Btyan;
I seriously doubt the "shake table" theory. Heat cycling is the only
reliable way to stress relieve metal that I know of.
If anybody wanted to try the high power "Shake Table" idea, too bad you just
missed a Raytheon (Hughes Aircraft) surplus sale that had a complete 12,000
pound shake table.
Regards, Neil Tucson, AZ
-----Original Message-----
From: Bryan Savage [mailto:basavage@earthlink.net]
Sent: Saturday, December 14, 2002 4:08 PM
To: Bob Jepson
Cc: Land Speed
Subject: Re: Stress relief
I have read that a rebuildable engine out of an old school bus or truck
is good for racing use because it is "Seasoned".
I also read about vibrating parts with a high power "Shake Table"
will relieve stress.
Are these Racing Myths?
Bryan ( wondering & wet )
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|