land-speed
[Top] [All Lists]

RE: Parachute Release...

To: "Glen Barrett" <speedtimer@charter.net>, "DrMayf"
Subject: RE: Parachute Release...
From: "Russel Mack" <rtmack@concentric.net>
Date: Fri, 6 Dec 2002 22:08:24 -0600
OH, the vision!

Can't you just see them when they "pop" into full bloom??!!!  If that didn't
knock your eyes out, nothing would!  ROFLMAO!!!

The best kind would be those stitched into concentric circles, like some
girls used to wear in the '60s-- those made for grand, conical shapes!

Good one, Glen!

Russ

-----Original Message-----
From: owner-land-speed@autox.team.net
[mailto:owner-land-speed@autox.team.net]On Behalf Of Glen Barrett
Sent: Friday, December 06, 2002 4:01 PM
To: Russel Mack; DrMayf; land-speed@autox.team.net
Subject: Re: Parachute Release...


Russ, maybe a couple of big pink ones made by a bra maker. Could be a
sponsor like maidenform  or Virginia's secrete.
Stopping power by BOOBS.
Glen
----- Original Message -----
From: "Russel Mack" <rtmack@concentric.net>
To: "Glen Barrett" <speedtimer@charter.net>; "DrMayf" <drmayf@teknett.com>;
<land-speed@autox.team.net>
Sent: Friday, December 06, 2002 1:54 PM
Subject: RE: Parachute Release...


> Mayf:
> you can stow the chutes in the continental tire cover.  That'll be really
> trick!
> Russ
>
> -----Original Message-----
> From: owner-land-speed@autox.team.net
> [mailto:owner-land-speed@autox.team.net]On Behalf Of Glen Barrett
> Sent: Friday, December 06, 2002 2:31 PM
> To: DrMayf; land-speed@autox.team.net
> Subject: Re: Parachute Release...
>
>
> Mayf.
> The release can be mounted anywhere it is easy to reach but must be within
> the confines of the driver
> fully suited with arm restraints. You can use air or electric release
system
> with a button on the steering wheel
> but must be able to over ride it in the event of airor electrical failure.
> Plastic covered chute release cable systems
> tend to melt if there is a fire or near any heat producing elements. Go
with
> what the manufactures suggests for
> best results.
>
> Glen
> ----- Original Message -----
> From: "DrMayf" <drmayf@teknett.com>
> To: <land-speed@autox.team.net>
> Sent: Friday, December 06, 2002 12:08 PM
> Subject: Parachute Release...
>
>
> > What should I use for my parachute release system? Morse cable? Choke
type
> > cable? Or what? And are there any restrictions that are put on where I
can
> > mount the pull handle?
> >
> > mayf, the red necked ignorant desert rat pi PAAAHrump where the chickens
> run
> > wild...

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.


<Prev in Thread] Current Thread [Next in Thread>