Mayf:
you can stow the chutes in the continental tire cover. That'll be really
trick!
Russ
-----Original Message-----
From: owner-land-speed@autox.team.net
[mailto:owner-land-speed@autox.team.net]On Behalf Of Glen Barrett
Sent: Friday, December 06, 2002 2:31 PM
To: DrMayf; land-speed@autox.team.net
Subject: Re: Parachute Release...
Mayf.
The release can be mounted anywhere it is easy to reach but must be within
the confines of the driver
fully suited with arm restraints. You can use air or electric release system
with a button on the steering wheel
but must be able to over ride it in the event of airor electrical failure.
Plastic covered chute release cable systems
tend to melt if there is a fire or near any heat producing elements. Go with
what the manufactures suggests for
best results.
Glen
----- Original Message -----
From: "DrMayf" <drmayf@teknett.com>
To: <land-speed@autox.team.net>
Sent: Friday, December 06, 2002 12:08 PM
Subject: Parachute Release...
> What should I use for my parachute release system? Morse cable? Choke type
> cable? Or what? And are there any restrictions that are put on where I can
> mount the pull handle?
>
> mayf, the red necked ignorant desert rat pi PAAAHrump where the chickens
run
> wild...
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|