mayf,
Everyone is so full of turkey and stuffing that they can't reach the
keyboard.
Howard
----- Original Message -----
From: "DrMayf" <drmayf@teknett.com>
To: <land-speed@autox.team.net>
Sent: Friday, November 23, 2001 6:35 PM
Subject: %$#%#^@&#@^% -4 AN fittings and hoses
> Since the list is quiet, I thought I'd ask about the easy way to
assemble -4
> AN fittings and stainless braided hoses. I'll bet this is the least uses
> combination of all! What a chore. But I finally got one end done...lots of
> trial and error practice. I finally cut the hose real square, wrapped with
> tape naturally, then gently ground it smooth on the side of my grinder
> wheel, carefully removed the tape (drat, some straggler strands escaped!),
> carefully set the nut on the hose and then whapped it mightily on the end
> with a non marring BOARD! Got that sucker on finally. Kept whapping it
till
> it was in too deep of course, so had to back it out a bit. Then put the
> screw in part in and that was hard to get threadded, sheesh! This process
> seemed to work ok...but, is there a better way? I will use nothing but -10
> size from now on, no matter what it is for.....
>
> And why is the list so quiet except for some chat about auto trannies?
>
> mayf
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
/// or go to http://www.team.net/cgi-bin/majorcool
///
///
|