Delimonene= ???
Joe :)
Rick Byrnes wrote:
> Ed,
> Try looking at surface finish and flatness again, of both the heads and
> intake. Perhaps mismatch of angles or unloading of the water port area when
> torqued.
>
> I have found that Loctite "Form a gasket" works better than RTV silicone
> sealers. Long term the silicone is not fuel resistant and has little shear
> strength, while Loctite does, and will seal well as long as the gaps are
> very small and metal to metal contact is maintained. Like you, I have been
> sealing my alum side draft manif to the alum head this way for some time.
> No gaskets at all, just the "Form a Gasket"
> There are some tricks to using anerobics. Cleanliness. Cleaning with
> solvent and Delimonene are essential, but we all know that.
>
> Rick Byrnes
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
/// or go to http://www.team.net/cgi-bin/majorcool
///
///
|