Bill,
The topic of block stressing is an interesting one. I had a customer who ran
solid side mounts and a mid plate on his blown, injected, nitrous squirted small
block 32 street-driven roadster. He kept blowing head gaskets and torching the
blocks and heads so I installed a front plate and he never had another problem.
I
really don't know if it made a difference but I got credit for solving a
reoccurring and expensive problem.
There isn't a competition car in drag racing with anything but front and mid
mounts and I have never heard of motors failing do to stress from
mountings...just driver abuse!!! Also, most drag stuff use lateral limit links
to
keep the motor/trans from moving fore and aft if the mid plate isn't securely
bolted into the chassis. In dragracing, this link system is good for a tenth or
so in e.t. on some cars.
Of course, horsepower comes into play when considering how to mount a
motor/trans
package. More power---stronger mounting required!
Hey Jerry,
Happy Mounting...hope you are not too confused!!!
joe
ardunbill@webtv.net wrote:
> Hi Rick, I am no expert, Joe Timney is an expert, but I like the rubber
> mountings and I see nothing wrong with four-point rubber mounts as long
> as the mountings are fully reliable. I'm using the original Ford rubber
> front mounts on my Ardun, and the GM rubber mount under the tailhousing
> of my Borg-Warner Super T-10 gearbox. I expect no trouble with any of
> these.
>
> Don't know about bracing twixt engine plates, far as I know the rear
> plate people use with solid mounts is a flat plate sandwiched between
> the bellhousing and the block flange, extending out to the frame, and
> any kind of fabricated solid mount to the front block mount points.
>
> Also don't know about suitability of a CV mid-way joint in your Buick
> driveshaft for racing, maybe somebody else does. If it was just viewed
> as an alternative u-joint, I imagine the rear part of the driveshaft
> would have to have a regulation loop around it to contain the shaft if
> the CV joint broke, and there again the front half of the driveshaft
> probably also needs a loop behind its front u-joint. Despite the
> presence of the crossmember tunnel. Dan Warner may say. I think these
> loops are a serious safety item, Keith Turk once broke a u-joint and
> even with the loop the gearbox tailhousing got hit sideways so hard it
> broke and the gearshift lever hit his leg HARD. And it really HURT.
> But didn't break his leg. Cheers Bill
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
/// or go to http://www.team.net/cgi-bin/majorcool
///
///
|