Ken
Why not run a spool??
Are you talking about 3's for the 1st gear in the T-10?
John Beckett
----- Original Message -----
From: "Ken Bond" <kmb2@humboldt.edu>
To: <land-speed@autox.team.net>
Sent: Sunday, November 12, 2000 6:35 PM
Subject: Ford 9" / posi / floating, etc.
> Folks,
>
> We have decided to put a Ford 9" under the rear of the 85 Vette for
running
> in D/GT... I am not quite sure HOW yet, but we are committed to going
there.
>
> I have an option to buy EITHER a posi unit or a non-posi unit from a guy
in
> Portland, OR that has a couple of both available (both are 28 spline). I
> am assuming that I DEFINITELY WANT the POSI unit. Is there any reason
that
> logic is faulty?
>
> Should I be concerned about full / semi floating in this application?
>
> Also, since I expect to be running a T-10 trans, I am looking at a couple
> of starting' gear ratio sets in the low 3's. Do they seem reasonable.
>
> thanks as always
>
> KEN
>
>
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> * Ken Bond, *
> * Prof. of Bus. Admin. *
> * Humboldt State Univ. ____________ *
> * Arcata, CA 95521 _______| 58 85 99 |_________ *
> * / How much horsepower / *
> * / Can I have and still / *
> * Wk.:707.826.4277 /_________ go to Heaven?______/ *
> * Wk Fax:707.826.6666 |_61______61_| *
> * Hm.:707.826.7764 I Never Drive Faster than *
> * Hm Fax:707.826.0334 My Guardian Angel Can Fly *
> * Internet: *
> * kmb2@humboldt.edu (office) *
> * ragtops@humboldt1.com (home) *
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
|