In a message dated 11/05/1999 8:52:33 AM Pacific Standard Time,
lsr_man@yahoo.com writes:
<<
Thanks for the info on the clutch and flywheel,
Doug. You made my day. I was dreading having to
pull that pan off this weekend. The flywheel is
all cinched up good and tight with safty wired
cap screws and all. I just have to bolt a clutch
in place before putting the tranny on. I'll use
the 11" incher. Thanks again.
>>
#Dick,
Unlwss you're drag racing, the 10" would be adequate. Do you have an
aluminum clutch to match the flywheel? Adequate aftermarket clutches for
Flatties are sometimes hard to find. A cheap one may "grenade" on you at high
RPM and ruin your day.
I presume that you're going to initially use the subject engine for
setup, and that you'll look into the insides before you race it.#Ardun Doug
|