I used 18g. aluminum sheet, no problems with water.
Rob
> On Oct 19, 2019, at 8:44 AM, Roland Wilhelmy <sentenac.rw@gmail.com> wrote:
>
> I used plywood from aircraft Spruce and Specialty. 3 ply. Finnish birch.
> Available in thicknesses from 1/64 â?? up by 64ths. Tested to German Lloyd
> specs. Something like five hours in boiling salt water.
> -Roland
>
>
> On Sat, Oct 19, 2019, 7:40 AM warthodson--- via Healeys
> <healeys@autox.team.net> wrote:
> What ever you use, consider that at some point in time they may get wet. For
> example, you might get caught in a heavy rain storm before you can find a
> spot to erect the top & install the side curtains (if your car has them). The
> material might buckle, warp or delaminate if it is not water resistant.
> Gary Hodson
>
>
> -----Original Message-----
> From: richard mayor <boyracer466@gmail.com>
> To: healeys <healeys@autox.team.net>
> Sent: Fri, Oct 18, 2019 1:53 pm
> Subject: [Healeys] Door card material
>
> I'm getting ready to make new door cards and trim my doors. My research has
> found that people use everything including ABS plastic, foam board, masonite
> and plywood. I'm leaning towards Baltic Birch plywood at this point but I
> would like the infinite wisdom of this list before I go down that, or any
> other, road
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|