Don?t use foam. It will rust out the tank and floor as it will absorb
and hold water.
Kees Oudesluijs
Op 18-5-2018 om 10:24 schreef Robert Begani:
>
> My new fuel tank in the BJ8 has similar problems in installation.?
> First of all, I noticed that the old tank installation allowed road
> splash water to enter the boot because the toward the forward end is
> tilted up to be able to screw into the fuel fitting and sponge rubber
> only touches the tank on the rear end of the tank.? My idea was to use
> additional foam tape on the forward end of the tank and silicone
> caulking to seal the opening.? Also, the tank is as loose in the
> straps so I used block of wood wedge to hold it firm temporarily. So I
> hope the group can describe how to install a new tank in and old car
> as allowing road water to enter the boot sounds illogical. My new tank
> is temporarily installed.
>
> Bob Begani
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs
> at chello.nl
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180518/be3d6cc6/attachment.html>
|