My new fuel tank in the BJ8 has similar problems in installation. First of
all, I noticed that the old tank installation allowed road splash water to
enter the boot because the toward the forward end is tilted up to be able to
screw into the fuel fitting and sponge rubber only touches the tank on the
rear end of the tank. My idea was to use additional foam tape on the
forward end of the tank and silicone caulking to seal the opening. Also,
the tank is as loose in the straps so I used block of wood wedge to hold it
firm temporarily. So I hope the group can describe how to install a new tank
in and old car as allowing road water to enter the boot sounds illogical. My
new tank is temporarily installed.
Bob Begani
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180518/0945e6ce/attachment.html>
|