healeys
[Top] [All Lists]

[Healeys] BN2 Fuel Tank

Subject: [Healeys] BN2 Fuel Tank
From: bspidell at comcast.net (Bob Spidell)
Date: Fri, 18 May 2018 07:06:10 -0700
References: <92667556.1334308.1526375126086.ref@mail.yahoo.com> <92667556.1334308.1526375126086@mail.yahoo.com> <913da640-5f31-314f-2940-4950badbe87d@comcast.net> <CAFBXTkKHd6bBU-0547Uy=veJvu-S2D1T7etf+bV2HDk2d-Ch3A@mail.gmail.com>
Point taken.? However, I've never had an issue doing this, as I believe 
the tank is adequately grounded by both/either contact with the metal 
straps and/or the brackets that hold them, and/or by the metal pipe, 
which is grounded by several P-clips that are screwed into the 
chassis.?? You can always run a small wire from a screw on the sender to 
the body somewhere if you're concerned.

Since the car is very effectively electrically isolated by the tires, 
the entire car can experience static buildup, and grounding the tank 
only disperses it throughout the chassis.? I've been zapped many times 
by my BJ8 which has a 'plastic' (mylar?) cover. Removing the cover 
creates quite a charge, esp. in low humidity. If I think about it, I 
ground myself to the car--usually I make contact with a bare leg to a 
bumper--before taking the cover off. The other concern is fueling, where 
the flow of fuel can create a charge.? Hopefully, the car gets grounded 
by contact with the pump nozzle (note the tank may be isolated by the 
rubber sleeve connecting the filler neck and the tank).? Fueling 
installations for piston-powered aircraft have a separate ground line 
that must be attached before making contact between the nozzle and any 
metal on the aircraft (usually, we connected it to the exhaust stack). I 
suspect--but don't know for a fact--that this is because the fuel line 
and nozzle don't have a ground lead 'built-in.'

Bob


On 5/17/2018 11:48 PM, Alan Seigrist wrote:
> At some point, however, the tank must have metal to metal contact 
> somewhere to prevent static charge build up and also to make sure the 
> gas guage works.
>
> On Tue, May 15, 2018 at 9:39 PM, Bob Spidell <bspidell at comcast.net 
>
>     Get some reinforced rubber stock--places like Orchard Supply
>     (maybe Lowe's, HD, etc.) sell it--and put a couple strips front to
>     back to level the tank and keep it off the boot pan.
>
>     BTW, if the tank hold-down straps have evenly-spaced holes they're
>     for copper rivets to hold a thick canvas-like padding.? You don't
>     want the straps rubbing against the tank either (substitute rubber
>     if you like).
>
>     Bob
>
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180518/fe15bd81/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>