...best thing to use is uncured rubber strip ? you moisten it with kerosene
which makes it slippery ? much easier to fit
Cheers
Peter
From: Charlie Baldwin
Sent: Saturday, May 27, 2017 1:05 AM
To: Healeys at autox.team.net
Subject: Re: [Healeys] 100 Windshield Assembly
When I did a couple of BT7 windshields some years ago the Moss rubber was way
too thick. Even though it is rubber it isn't very compressible. I measured
the thickness of the glass and channel and determined what thickness rubber was
required, which I got from Restoration Specialties in Windber, PA. They have
an online catalog, but I think they call it glazing tape. I put contact cement
on the rubber and the windshield to keep the rubber wrapped around while
tapping the frame onto the glass. The new glass wasn't at the same radius as
the old frame and one of the windshields broke down the middle after it was in
a while due to too much stress on the glass. Then I had to relieve the radius
of the frame a bit to match the replacement glass.
On May 26, 2017 at 12:28 AM Bob Spidell <bspidell at comcast.net> wrote:
IIRC, the discussion about 'too thick' rubber was for the U-channel seal, but
I may not RC. The glazing rubber we got from Moss years ago seemed to be the
correct thickness. I don't recall using a mallet or much force at all, nor do
I recall using any lubrication, but it was a long time ago.
Did you get the Triplex windshield, or the cheaper one? There may be some
issues with thickness between the two. We were able to reuse the windshield
that came with the car--I spent a day polishing out wiper scratches--and AFAIK
it was original, or an OEM replacement.
Bob
On 5/25/2017 6:29 PM, Michael MacLean wrote:
Thanks Bob. I have the glazing rubber from Moss, but I seem to remember a
problem a while ago about the rubber being too thick I hope not. The only
other question I might have is, did you use a rubber mallet? Do you need some
kind of lubrication? It looks to be a tight fit. Once it is on, I won't be
able to move laterally if it's too far to the right or left. Sounds like you
have to get ot right the first time.
Mike
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/mgcharlie
at comcast.net
--------------------------------------------------------------------------------
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170527/615f4f6c/attachment.html>
|